Dental wireless LED Curing Light Lamp Adjustable blue light Light Intensity meter US Item NO.: 16046373

7 Technical Parameters of the Product Handle and head Overall assembly size: 22.5mm*22.5mm*205mm Overall assembly weight: 110g Battery Classification by battery: Rechargeable battery Battery model: 18500 3.7V Battery capacity: 2000mAh Battery protection: Battery with overvoltage, overcurrent and short circuit protection Power adapter (charger) Input: 100-240V~50/60Hz0.4A Max. Fuse protector: T1A250V Output: 5V=1A LED lamp performance Wavelength: 385nm~515nm The typical wavelength peak of the LED lamp of the 465±5 nm and 400±5 nm curing light is: Classification: Class1 Emission limit (AEL): 3.9X10-J Inspection method: The LED light is on,indicating that the light is in good condition during correct operation. Diameter of light-emitting end face of the light-guide 10 mm element: Optical effective area: 78 mm² The standard of curing light requires the illumination in the Not less than 250mW/cm²wavelength range of 385nm~515nm (blue light): PENETRATING POWER EQUIPPED WITH 10W LED More-focused light output thanks to light angle of only 15.8°，ensuring good deep curing effect. Light intenstiy up to3000mw/cm², The high intensity brings sufficient curing depth, which can reduce the curing time and greatly improve the efficiency of resin curing 7 MODESCAN FULLY MEET VARIOUS CLINICAL NEEDS Normal Mode Constant light intensity: 1000-1200mw/cm² Suitable for most treatment scenarios, such as fillings, restorations, etc. Time setting: 5s, 10s, 15s, 20s High Mode Constantlight intensity: 1800-2000mw/cm² Suitable for quick curing. ensuring enough curing depth, Time setting: 3s, 5s Turbo Mode Time setting: 1s, 3s, 2700-3000mw/cm², Ultra-high light intensity enables 1 sec curing of 2mm resin. Ortho Mode Time setting: 3s*5, 3s*10, 2700-3000mw/cm², High light intensity with strong penetrability, especially suitable for orthodontic bracket bonding Soft Mode Light intensity is gradually increased, from 0 to 1200mw/cm² Time setting: 5s, 10s, 15s, 20s, Effectively reduce the, shrinkage rate of resin, Lower the risk of microleakage Pulse Mode The LED will stop for 0.4s at an interval of 0.6s curing, When working in a cycle of treatment. it can effectively reduce heat generation. efficiently dissipate heat and ensure the comfort of diagnosis and treatment, Time setting: 5s,10s.15s.20s VERSATILE BASE CHARGING BASEWITH BUILT-INLIGHT METER There is a light meter builtin the charing base. Accurate light intensity is required for efficient polymerization of the resin, bringing you and your patients the best treatment experience.